ITronixPal v20 iPhone iPod Touch CrackedCOREPDA

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • CYBER WEESJE
    Member
    • Mar 27
    • 9867

    [RELEASE] ITronixPal v20 iPhone iPod Touch CrackedCOREPDA

    ITronixPal.v2.0.iPhone.iPod.Touch.Cracked-COREPDA
    A must-have utility for electronics enthusiasts - whether you are a student, engineer, teacher, DIY-er, technician, or a designer. It is easy to use and extremely handy when you are working on your bench, without access to your personal computer. Get results, fast!



    FEATURES
    * 4,5,6-band resistor color codes translation from value entered and vice versa.
    * For the 4-band tool, it also displays equivalent value of Ceramic Capacitors, Electrolytic Capacitors, Inductors and chip resistors. Also available a tool to translate Electrolytic capacitor's voltage rating codes.
    * Ability to detect if the resistor value chosen is of EIA Standards or not.
    * If value entered is not found, the nearest value will be shown.
    * Shows the color codes in words, to prevent misinterpretation of colors.
    *Ohm's Law, Charge and Capacitance, Transistor Gain and Time Constant equation calculator.
    *Beautiful graphics.

    *Circuit Calculators:
    -Calculate the total value for parallel R or L, and series C.
    -Calculate and design your voltage divider circuit.
    -Calculate and design your zener voltage reference circuit.
    -Calculate and design your LED circuit.

    What's new

    1. Revamped user interface and graphics.

    2. TWO BONUS UTILITIES! (as promised):-

    * A simple flashlight (with 4 colors - white,red,green,blue). Useful for video color referencing. Starts always with a white light. The light is particularly useful if you are soldering away in a dark place or cannot find that component that just dropped from the table.
    * Tone generator - generate tone/test signals from your iPhone. Choose a frequency and it will play it in a loop. Also available is the Sweep function where the tone is produced for the whole range of frequencies - from 20Hz to 20kHz (useful to measure frequency response of a system). And yes, switch on that 20kHz to rid off insects if you are soldering in the woods! Also available a White and Pink noise generator.

    *Added More Circuit Calculators:
    - Calculate and design your RC filters - High pass/Low pass/Band pass.
    -Calculate and design your Regulators'/Power Transistors' power dissipation and calculate its required heat sink sizes.
    -Calculate and design your Inverting and Non-inverting Operational Amplifiers.

    GRTZ CYBER WEESJE
    SENIOR ADMIN@SPJ HIT THANKS ON THE WAY OUT
    Attached Files
    video walk through on how to flash diamond/tp CLICK HERE
    NOOB CHECK SPJ TOUR BY D/\SH CLICK HERE
    LEARN HOW TO FLASH ROM CLICK HERE
    TUTORIAL BY ZAY HOW TO INSTAL TFD3THEMES General Forum Tips CLICK HERE
    sigpic
Working...